SPECSTECH AFRICA LTD is organising an intensive OIL and GAS training in LAGOS to develop the requisite skills and capacity in Nigerians in other to tap into the numerous opportunities that exist in the oil and gas sector..we offer training to ,consultant,engineers,managers,senior and junior staff in the oil and gas industry as well as fresh graduates and focused undergraduates.our interest is for those pursuing excellence and improvement in their career.our work force is made up of young Nigerian engineering graduates who have acquired software skills through the PTDF scheme.our goal is to transfer knowledge at its best.The softwares we offer are used mostly by SHELL,MOBIL,SCHLUMBERGER,TOTAL,ELF,AGIP AND other major oil companies in Nigeria.
OIL & GAS PROCESS MODELING WITH ASPEN HYSYS
The parameters we use for the design or construction of 0il ad gas facilities is gotten from process design. This information is part of what we call deliverables in
engineering design. Hysys generates process deliverables like pressure, temperature, flow rate and other heat and mass properties which we use in the actual
plant design.
We have outlined about 10 modules involved in process modeling taking a guide from PTDF scheme and our over 5 years experience in process design and training
so as to simplify the understanding of the software. In addition the trainee will undergo a project on low station revamp, involving 8 oil and gas wells.
scope
•Introduction to HYSYS
• Propane Refrigeration loop
• Refrigerated Gas Plant
• NGL Fractionation Train
• Oil Characterization
• Gas Gathering
• Two-Stage Compression
• Acid Gas Sweetening with DEA
• Natural Gas Dehydration with TEG
• Reporting in Aspen HYSYS

HYSYS DYNAMIC SIMULATION
The dynamic simulation specifically handles EQUIPMENT sizing and process control
1. REVISION OF STEADY STATE
2. BASIC CONTROL THEORY
3. PRESSURE-FLOW RELATIONSHIP
4. TRANSITIONING FROM STEADY STATE TO DYNAMICS-MODYFYING THE STEADY STATE
5. SIZING UNIT OPERATIONS (DE-PROPANIZER COLUMN, SEPERATORS etc)
6. USING THE DYNAMICS ASSISTANT AND ACTIVATING THE DYNAMIC MODE
7. INSTALLING THE CONTROLLERS (PID)
8. SETTING UP STRIP CHARTS
9. RUNNING AND MONITORING DYNAMIC SIMULATION.

For further enquiries, you can contact the following numbes - 07082876432 or 08028757481 or you can send a mail to [email protected]