The following vacancies exists in a leading Telecoms service provider in Nigeria.

1. BSS/TRANSMISSION ENGINEER

DUTIES
1. Responsible for the BTS cabinet installation and running of power cable and E1 (Hardware Completion) during projects.
2. BTS and BSC Installation and commissioning.
3. Ensure proper earthling and termination of E1 and alarm cables.
4. Responsible for Antenna installation/feeder cable installation.
5. Responsible for Clearing of Alarms arising from project executed.
6. Responsible for Assembling and coupling of Microwave Radio not more than.
7. Responsible for Hoisting and installation of the radio (Ensure the feeder and connectors are properly terminated).
8. Responsible for the Installation of IDU and ensure that proper earthling is done.
9. Responsible for the Provision of suitable power -48v to the IDU
10. Ensure proper panning according to given parameter.
11. Ensure the required RXL (Receive Signal Level) is achieved
12. Open the E1 port and terminate the E1 Cable properly on the crone block.

2. RF ENGINEER

DUTIES
1. Carry out SSV – Site verification
2. Carry out Cluster/ data Drive test and Ping Test.
3. Carry out Physical site Optimization and Benchmark DT.
4. Ability to write reports
5. Knowledge of actix and navigator equipment is key.

3. FIBRE OPTICS ENGINEER

DUTIES
1. Carry out comprehensive survey for cable route.
2. Prepare suitable Engineering drawing for fibre route.
3. Ensure depth of fibre trench is up to design specification.
4. Ensure proper laying of HDPE pipe and backfilling of sand.
5. Responsible for the Construction of JB.
6. Responsible for the Splicing of fibre.
7. Responsible for the assembling and fixing of Patch panel.
8. Carry all tests (Power meter Test, continuity Test) and record as necessary.
9. Prepare as built document at the end of fibre project.
GENERAL REQUIREMENTS
1. Good Degree or HND in Engineering (Electrical Electronics)
2. 2 years experience and above.
3. Good knowledge of BSS, Drive Test, Transmission, BTS.
4.Knowledge of actix and navigator equipments for candidates applying for RF Engineer.
5. Candidates must be between the ages 25 - 35
METHOD OF APPLICATION
Intrested applicants should forward their resume to:
[email protected]
CLOSING DATE
Applications must be submitted before May 26, 2011