Etap Do it yourself manual consists of
Section 1: How to build and manipulate a one-line diagram
Section 2: How to set up and run a load flow study
Section 3: How to set up and run an unbalanced load flow study
Section 4: An introduction to ANSI and IEC short circuit studies
Section 5: How to set up an run arc flash analysis
Section 6: How to set up and run both static and dynamic motor acceleration studies
Section 7: A brief overview of a harmonic analysis of a system
Section 8: How to simulate and analyze system transients
Section 9: An overview of the basic operation of the Protective Device Coordination (Star) module
Section 10: An introduction to Optimal Power Flow analysis
Section 11: How to setup and run a reliability analysis
Section 12: An overview of the DC Load Flow module
Section 13: How to run a DC Short-Circuit study and make multiple study cases
Section 14: An introduction to Battery Sizing and Battery Discharge
Section 15: A brief overview of the Underground Raceway Systems module
Section 16: How to build and run studies on a Ground Grid Systems
Section 17: How to set up and build a Cable Pulling System
Section 18: How to set up and connect Panel Systems to existing networks
Section 19: A detailed explanation of the output report formats
Section 20: An overview of the libraries of ETAP
Please we won't go outside this course outline and they are with graphics to help you while studying
In each section, you will receive a training manual which you can follow (That is if you requested for a training). At the end of the self tutor, you will send your questions and it will be reviewed together.
For more enquires, please mail [email protected]