Piping design & pipe stress using pdms,bentley autoplant & caesars 11

SOLTECH PIPING DESIGN SOLUTIONS PRESENTS PIPING DESIGN SOFTWARE TRAINING IN VANTAGE PLANT DESIGN MANAGEMENT SYSTEMS (PDMS) ,BENTLEY AUTOPLANT AND INTERGRAPH CAESARS 11 FOR PIPE STRESS ANLYSIS FOR 2011.
VANTAGE PLANT DESIGN MANAGEMENT SYSTEMS (PDMS) IS A PLANT DESIGN SOFTWARE USED TO DESIGN ANY TYPE OF PLANT-FROM PETOCHEMICAL PLANT.OFFSHRE PLATFORM, CHEMICAL,PHARMACEUTICAL ,POWER PLANTS, WASTE WATER TREATMENT PLANT , AND COGENERATION FACILITIES.
THE FOLLOWING MODULES WILL BE TREATED:
Equipment Design
Piping Design & Generation of Isometrics for M.T.O (ISODRAFT)
Reporting and Clash Detection
Advanced Steelwork Design
Advanced Drawing Production
Time: 9AM-12NOON EVERY SATURDAY.
Note: The student will be introduced to Piping design concept during the course of the program. A Depropanizer plant DEMO project will be used for the training.The same project will be used for BENTLEY AUTOPLANT TRAINING

INTERGRAPH CAESARS – II is used for Pipe Stress Analysis of PIPING SYSTEMS. It performs engineering analysis on a piping system to ensure the safety against the failure of the system by verifying the structural integrity against the loading conditions, both internal and external, expected to occur during the lifetime of the system in the plant. Caesars 11 takes the job from design by rule to engineering analysis.
THE FOLLOWING MODULES WILL BE TREATED:
Introduction to Pipe Stress Analysis
Why Perform Pipe stress Analysis.
Designing for Sustained Load and Expansion load.
Nozzle Thermal Growth Calculations – pumps, vessels, heat exhangers.
Piping Input Spreadsheet.
Modelling of Piping Isometrics – Bends, Reducers, Valves, Loops etc.
Performing Static Analysis.
Modifying Load Cases.
Hanger Selection.
Set up of Wind Load Cases.
Set up of SUS, OPE, EXP, HYD, HGR, & OCC loads.
Load Case Editor
Viewing Reports
Evaluating API 610 Pump Nozzle Loads
Local vessel flexibilities using WRC 297
including vessel modeling
Evaluation of local vessel stresses according to WRC 107
Practical Examples – Input, Analysis & Redesign

Time: 1:30PM-5PM EVERY SATURDAY.
FOR MORE INFORMATION:CONTACT SOLOMON WEBER 08036316839/07059529865 or 08083582114 OR MAIL ME [email protected]
Venue:10 ISREAL OYEKAN STREET OFF BAJULAIYE ROAD SOMOLU,YABA. LAGOS STATE
Each of the program will take five weekends, Saturdays only. Certificate will be issued at the end of the program.
NOTE:TRAINING MATERIALS WILL BE PROVIDED