Oil and gas Process Modeling and Engineering design begins on the 20th of February,
The next batch of training for oil and gas Process Modeling and Engineering design begins on the 20th of February, 2012 and is limited to 10 participants only; details of the training is as follows:
Training Fee: N50, 000.00 only
Time: 5.00 to 8.00pm (Mon-Fridays)
Training Duration: 3 weeks
Who should attend?
· Engineering graduates of Chemical, Mechanical, Petroleum, and Production Engineers
· Downstream professionals, such as: facility engineers and Operators.
What is the objective of this training?
The aim of this course is to provide attendees with a common awareness of Oil and Gas industry facilities Design; from the unit operations point of view. The package is presented in 14 Modules.
At the end of this course, trainees should be able to have vivid knowledge of the following areas:
MODULE I
Overview of Onshore, Offshore and Subsea Oil and Gas Facilities
MODULE II
In-country Oil & Gas Regulations.
International Codes & Standards.
Specifications, Recommended Practices, Publications, Bulletins &
Technical Reports.
MODULE III
Overview of Typical Engineering Drawings
Applicable Process / Piping Interface Drawing.
Applicable Process / Instrumentation / Piping Interface Drawing
Applicable Process / Electrical Interface Drawing
Applicable Process / Electrical / Piping Interface Drawing
Applicable Process / Mechanical Interface Drawing
MODULE IV
Conceptual Engineering
Front End Engineering Design
Detailed Engineering Design
Some Important Document Items in a Design engineering Contract.
MODULE V
Site Visit Activities
Check List
Sketching
Red Line Mark-up
Site Visit Report
Understanding Project Scopes
MODULE VI
Overview of API RP 14C
General
Safety Device Symbols and Identification
Introduction to Safety Analysis and System Design
Protection Concepts and Safety Analysis
MODULE VII
Overview of typical Flow Diagram
The Block Flow Diagram ? BFD
Process Flow Diagram
Piping and Instrumentation Diagram
MODULE VIII
Introduction
Understanding the various classes of pipes and their sizes
Typical Application
The Principle of Line Sizing (single phase / liquid & gas)
The Principle of Line Sizing (2 phase /liquid & gas)
Line identification on P&IDs and Process Plants
Pump Sizing and Selection
MODULE IX
Valve Types and Functions
Control Valve Types and Functions
MODULE X
Orifice Meters
Types of Orifice and Application
The Principle of Orifice Sizing
Blowdown
Calculating Blowdown Time
Calculating Blowdown Pipes Size and Length
MODULE XI
Generating P&ID Index
Generating Legend Sheet
Generating Process Flow Diagrams
Generating Piping & Instrumentation Diagrams
MODULE XII
Generating Piping Line List
Generating Process Tie-in Schedule
Design Considerations
MODULE XIII
Generating Process Datasheet
Typical Process Datasheet
Purpose of the Process Datasheet
MODULE XIV
Understanding SAFE Chart
Typical SAFE Chart
Preparing SAFE Chart
Training sessions are limited to 10 participants only; you are however advised to make a down payment early to secure a seat.
Payment details are as follows;
Accnt name: COD Energy Services Limited
Sterling Bank
Accnt no: 506202839110
No.93 Tombia Extension road, new GRA phase II,
Tel: +234 84 8900825
Email: [email protected]
Website: www.cod-energyservices.com
