Stress Analysis - Caesar II


For more info contact: Tel: 08133476558, 07085740887
Address: Opebi, Ikeja, Lagos State, Nigeria
Email: vogwconcept50 (at) gmail.com


Port Harcourt contact: 08032766980

MODULE I

Overview of CAESAR II functions and how to use the program

• Detailed, important modeling issues – bends, reducers, valves, rigid elements, and
control parameters, non-linearity of restraints, connecting nodes, built-in
databases and assorted modeling issues.

MODULE II

• Practical examples using CAESAR II; input, analysis & redesign

• Theory - Designing for sustained loads; support configuration issues,
• Spring hanger design, optimization of sustained loads.
• Practical example

• Theory - Designing for expansion loads; flexibility
• Practical Examples

Detailed problem solving of a complex model, including:
• Imposed thermal displacements
• Expansion joint modeling & evaluation
• Structural steel modeling
• Spring hanger design
• Combining steel with piping

MODULE III

• Problem Solving Workshop – detailed example where each student works
independently, applying what is learned to solve a variety of stress and equipment
load problems.

• Buried pipe modeling.

MODULE IV

Introduction to Dynamic analysis


• Modes and mode shapes
• Modal analysis
• Spectral Analysis; Impact & Earthquake analysis Time History Analysis
Harmonic loads & harmonic analysis
• Relief valve firing
• Example problems including:

MODULE V


Equipment Component and Compliance

• Intersection Stress Intensification Factors
• Bend Stress Intensification Factors
• WRC 107 Vessel Stresses
• WRC Bulletin 297
• Flange Leakage/Stress Calculations
• Remaining Strength of Corroded Pipelines, B31G
• Expansion Joint Rating
• Structural Steel Checks - AISC
• NEMA SM23 (Steam Turbines)
• API 610 (Centrifugal Pumps)
• API 617 (Centrifugal Compressors)
• API 661 (Air Cooled Heat Exchangers)
• Heat Exchange Institute Standard For Closed Feed water Heaters
API 560 (Fired Heaters for General Refinery Services)

Examples
Routing Of Flare And Relief Valve Piping
Stress Analysis of Jacketed Piping System using Caesar II
Stress Analysis of Column piping system using Caesar II
Stress Analysis of Centrifugal Compressor Connected Piping Systems using Caesar II
Stress Analysis of PSV connected Piping systems using Caesar II
Alignment Check Methodology in Piping Stress Analysis using c
Flange leakage check using Caesar II
Fatigue analysis using Caesar II
Mechanically induced vibration problems & solutions
• Flow induced vibration problem & solution
• Time History analysis and evaluation of impact load (steam hammer) with
• dynamic restraint (snubber)
• Spectral analysis of impact load (Relief valve firing)

For more info contact: Tel: 08133476558, 07085740887
Address: Opebi, Ikeja, Lagos State, Nigeria
Email: vogwconcept50 (at) gmail.com

Port Harcourt contact: 08032766980